en:cube:install
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:cube:install [2021/09/18 19:04] – [During the install] celo | en:cube:install [2022/09/16 13:07] (current) – [After the install] celo | ||
---|---|---|---|
Line 286: | Line 286: | ||
```bash | ```bash | ||
sudo sed s/ | sudo sed s/ | ||
+ | sudo sed s/ | ||
sudo sed ' | sudo sed ' | ||
``` | ``` | ||
Line 317: | Line 318: | ||
sudo systemctl start ynh-vpnclient-checker | sudo systemctl start ynh-vpnclient-checker | ||
``` | ``` | ||
+ | |||
+ | #### Roundcube fails to install on Lime 1 | ||
+ | |||
+ | Roundcube require more than 500M to install. On lime 1, it's necessary to add swap. You can do it by running the following : | ||
+ | |||
+ | ```bash | ||
+ | sudo fallocate -l 1G /swapfile | ||
+ | sudo chmod 600 /swapfile | ||
+ | sudo mkswap /swapfile | ||
+ | sudo swapon /swapfile | ||
+ | ``` | ||
+ | You can verify that swap is available : | ||
+ | |||
+ | ```bash | ||
+ | sudo swapon --show | ||
+ | ``` | ||
+ | |||
+ | This should return a line about the swap. | ||
+ | |||
+ | Then edit your fstab file to activate the swap on startup : | ||
+ | |||
+ | ```bash | ||
+ | sudo nano /etc/fstab | ||
+ | ``` | ||
+ | |||
+ | Add the line : | ||
+ | ```bash | ||
+ | /swapfile none swap sw 0 0 | ||
+ | ``` | ||
+ |
en/cube/install.1631984665.txt.gz · Last modified: 2021/09/18 19:04 by celo